DF165 BMW Fault Code

Description:

The issue covered by the bulletin involves a power steering noise/whine or fluid leak from the power steering pump, gear or high pressure side power steering hose during extreme low outdoor temperature operation.

DF165 Code Symptoms :

The rule of DF165 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of DF165.

Likewise, overriding the OBD system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Diagnosis And Repairing DF165

DF165 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

How to fix DF165 code ?

• Continuous oil flow to the VCT piston chamber
• EVAP canister or fuel tank leaks
• Ignition coils circuit poor electrical connection
• Variable Valve Timing (VVT) circuit is open or shorted

Circuit High Input codes like DF165 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.